CHOPPER FH100
Combine harvester with cutterheads that with its standard equipment is designed for agricultural uses in cultivated lands, allows to mow, chop and expel forage crops, such as alfalfa, hay mixtures, grasses and corn, among others. The harvester can be used to condition hay under very dense crop conditions, where a conventional mower would not work.
The Model F100 cuts with a width of 1.83 m. Its 40 rotor blades, with double edge and free swing, cut even the hardest materials. The cutting height is adjustable from 5 to 18 cm. The large 3m auger carries material up to the chopping head. The large diameter auger has an adjustable deflector that prevents recirculation. This results in greater harvesting capacity and cleaner fields. Axle and auger bearings are fully protected, allowing the Model F100 to work under the most difficult conditions.
The Model F100 cuts with a width of 1.83 m. Its 40 rotor blades, with double edge and free swing, cut even the hardest materials. The cutting height is adjustable from 5 to 18 cm. The large 3m auger carries material up to the chopping head. The large diameter auger has an adjustable deflector that prevents recirculation. This results in greater harvesting capacity and cleaner fields. Axle and auger bearings are fully protected, allowing the Model F100 to work under the most difficult conditions.
Cutting Width
Rotor Speed Rotor Flails Cutterhead Knives Cutterhead paddles Cutterhead speed |
6 ft.
1, 373 rpm 40 3 Standard Cupped 966 rpm |
TRANSMISSION
HITCH & FEEDING
ROTOR & CUT PROCESSOR
Diameter mm (in): 89 (3.5)
Cutting width cm (in): 183 (72) Blades number: 40 double-edged reversible. Type of Blades: Flails (double-edged curved blades) Optional Blades mm (in): Short Flais 64 (2.5) Protection against rocks: Standard Cutting Control: skids and floating spring Cutting height cm (in): Adjustable between 5-18 (2-7) Cut processor type: Chopper-blower head Number of blades at the wheel: 2,3 or 6. |